Design categories

1, the traditional design and green design
Traditional design only considered qualified to design and manufacture molds. And not too much about the material does have an impact on the environment. Producing dies after the reprocessing, recycling, and so on. From beginning to end in the mold of green design to consider the impact on the environment, but also consider recycling of mould.
2, material selection
Mold material green degree of Green has a very important impact on the performance of the final product. Materials selection in green design must be established on the basis of green materials. abandon chemical methods used in surface treatment of materials. replaced by physical means to achieve the purpose of anti-corrosion or easy to demould. Select high quality mirror surface machining of die steel mold cavity; stainless steel materials to processing corrosion of molds instead of plating; or less harm to the environment and alternative to chrome plating nickel-phosphorus plating.
Green should have the basic properties of materials are: ① low pollution, low energy, low cost: Secondly, easy processing and processing of non-polluting or less polluting: third, biodegradable, reusable.
3, design standardization
Die standardization is a prerequisite for organizations mold production. Mold production is to improve quality, shorten manufacturing cycle, the key to reducing costs.
(1) and the purchase of standard mould base and other parts. Die sets and standard parts by specific manufacturers, enterprises through social division of labor for production, so that the optimal allocation of limited resources. Mold usually just punch and can no longer be used after scrapped. formwork still intact. use reuse of standards help to die. Stamping die and mold injection mold has many types of formwork is composed of standard upper and lower molds. Guide post. Guide bushings and other components. At the same time. mould standardization can make mould using equipment significantly reduced, thus saving resources. Also helps to manage.
(2) mold the structural unit of standardization. So that you can accelerate design speed, shorten design cycles, process management.